 | | Re: Spike protection
|
|
Terry, If you have the L293D or the SN754410 motor driver chips, then the diodes are present. - Prabal (...) (30 years ago, 12-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: 100 sensors
|
|
(...) A resistor ladder is simply several resistors, connected in series with a switch between each one. On the handyboard you would do something like this: VCC ---\/\/\/---\/\/\/--.../---...--- | | | | | | \ SW1 \ SW2 \ SW3 \ SW4 \ SW5 | \ \ \ \ \ (...) (30 years ago, 12-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR Collision avoidance
|
|
(...) My question is...in the first diagram (below) the resistance is 220 ohm ie 0.2KOhm But in the second diagram the resistances are 2.2KOhm Which is the correct one? ---...--- (...) (30 years ago, 12-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | ds1233-10
|
|
I have had trouble finding this part(DS1233-10). Does anyone know the properties of this part or an acceptable replacement? Jim Hamilton (30 years ago, 13-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Flame detection
|
|
What are some common methods people use to detect candle flames in a room filled with flourecent and/or halogen lights? THat is, what does one use to differentiate between ambient and flame lights??? Sincerely, Yoni Garbourg << To succeed, Atificial (...) (30 years ago, 13-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | High amperage charge
|
|
I have read in the HB Manual that people have experienced difficulty when useing high amperage transformers to charge the HB.I am interested in chargeing the HB with a 12 volt automotive circuit.Is this possible. Yours sincerely Joe Martin (...) (30 years ago, 13-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Ascii to integer...
|
|
Is there any function to convert Ascii to integer on the Handyboard? Yours Jon ---...--- Web : (URL) : (URL) jonko@gyda.hiof.no ---...--- (30 years ago, 13-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Servos
|
|
I have tried to use my servo with the HB, but the icb that I have does not reflect the documentation in given in the HB manual that I have. There is reference made to servo_on() and servo_deg() which is not in the icb file that I have of the servo. (...) (30 years ago, 13-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR Collision avoidance
|
|
(...) Resistors in series with LEDs are generally current limiters, meaning that the LED is very low resistance when conducting, so the resistor is the determinant of current flow. With the little colored LEDs I teach my students to hook up a 1K pot (...) (30 years ago, 13-Mar-97, to lugnet.robotics.handyboard)
|
| |
 | | Newbie
|
|
Hello! I am a high school senior working on a project for Tech Challenge '97 here in San Jose, California, and my team has decided to use the Handy Board as our processing/control device. I have a few questions With a basic HB, could we run (2) (...) (30 years ago, 13-Mar-97, to lugnet.robotics.handyboard)
|