 | | Re: D0 - D7
|
| Mar, This is what I've learned about the handyboard so far, and hopefully it will give you a little insight into what's going on with D0-D7 (the external bus). Because of the way the handyboard is configured, it's operating in special test mode. In (...) (30 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
| | |  | | as11 assembler
|
| Hi, This may be a dumb question, but I hope someone will oblige me anyway. I was checking out the handyboard website, and I wasn't able to find a PC version of the as11 assembler. Does anyone know where I can get a copy? Thanks, Maria ---...--- (...) (30 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
| | |  | | Servos and Handyboard.
|
| Hi Everyone. I'm doing a project on controlling servos using the handy board (actually, I'm building a camera rig with servo controls and interfacing this tho the www) My problem is this: when i try to control both servos at the same time, using the (...) (30 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
| | |  | | Re: motor voltages
|
| David, I would be interested in seeing a schematic on the wiring of the diode array. I am not sure of how it goes - exactly. I'm not located near a dedicated fax. I was wondering if it might not be too much trouble to sketch the schemtic on some (...) (30 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
| | |  | | Re: Servos and Handyboard.
|
| you can't power 2 servos from the hb's own +5v supply. get a separate 5v supply (linear regulated, *noT* a switching supply, OR batteries) and run your servo power from that. connect this external supply ground to the HB motor ground (on J13). -Fred (...) (30 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
| |