 | | Re: stalled motor detection
|
|
Shaft encoders are hard to beat. If the wheels are commanded to turn and aren't, that's a good indication that something is screwy. Plus, if you're doing dead reckoning, you need them anyway so they are already there! Gary Livick (...) (27 years ago, 27-Oct-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: stalled motor detection
|
|
If a motor stalls, it draws a lot of current (compared to normal operation). You can measure that quite easilyusing dedicated chip, or by measuring the voltage over a small resistor in series with the motor: if more current is draw, the voltage drop (...) (27 years ago, 27-Oct-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Chaining multiple RCX's output to input
|
|
Stephen Unwin <lego-robotics@crynwr.com> wrote in message news:Marcel-1.53-102...n.co.uk... (...) That makes sense cause the RCX has a 10K pulling the input up to 5V. The 10K you put in series with the motor will put the voltage at half way (2.5V) (...) (27 years ago, 27-Oct-99, to lugnet.robotics)
|
| |
 | | Re: Group to discuss Teaching Lego Robotics?? lugnet.robotics.teaching ???
|
|
(...) I think that might have been me. I was sitting in the front row right across from Mitchel. (...) Rich (27 years ago, 27-Oct-99, to lugnet.robotics.rcx.nqc, lugnet.admin.general)
|
| |
 | | 1.0 to 1.5 upgrade
|
|
Below are some products offered by (URL) I do not understand is that the upgrade kit from 1.0 to 1.5 can already be ordered, but the complete 1.5 will be available in January 2000. Can somebody explain? Harrie de Leeuw The Netherlands 9747 LEGO (...) (27 years ago, 27-Oct-99, to lugnet.robotics)
|