 | | Re: IR collision avoidance
|
|
Hey Chris, Thanks for the ideas, one questiom?. Can you pass along the Radio Shack part numbers? It seems like there are older and newer RS parts out there, what are you using? JTW In your message you said: (...) (30 years ago, 24-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | Using PD2 and PD3
|
|
I am building the circuit that is in the mobile robots book on pg. 108 to turn on and off my IR led's. Is it best to use the bit_set to turn them on and off? Where is the best place to get the 5 volts I need for the 74o4 chip? How do you read the (...) (30 years ago, 24-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR collision avoidance
|
|
This question seems to come up a lot here so I thought I'd post to the list rather than reply individually. Here's what I'm doing for IR collision avoidance. First, the hardware: I'm using 3 Radio Shack IR LED's in parallel and 3 Radio Shack IR (...) (30 years ago, 24-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | IR Collision avoidance
|
|
Chris or anyone who cares to respond, You put your message on the mailing list concerning the IR avoidance. I have a question about the hardware also. How are the leds powered? Are you pulsing them some way or what? I guess the decoder is what is (...) (30 years ago, 24-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR collision avoidance
|
|
(...) I don't have the RS part numbers, but I bought them within the last few months so if there are "old" and "new" ones mine are probably "new". I checked out the RS web page and found that what they currently have is RS part number 276-137, and (...) (30 years ago, 24-Feb-97, to lugnet.robotics.handyboard)
|