To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1471 (+5)
  LMD18200 Motor driver
 
Is there a way to use the LMD18200 motor driver as a replacement for the motor chip on the handyboard? I know that they are not pin compatable but is there some type of interface that can be built easily? Thanks. Keith Keith Soldavin (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Re: Motors & handyboard
 
(...) Unfortunately this is the LEAST amount of current the motor will draw when operating. You have measured the 'unloaded current'. Now, while you have your motor running, grab the shaft between your fingers and stop it, and measure that current. (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Re: Automatic feeding.
 
(...) Here's an idea for you: For a mechanical system you could use two 'wiskers': one on top and one on the bottom of the 'bot. (Or one each side.) You set up the 'feeding pen' to be two parallel metal plates. Set them up so that the 'bot can roll (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Re: Motors & handyboard
 
(...) EE Question: How do you use a multimeter to measure the current? I was told that you need a current probe to do this kind of thing. ?? (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Re: Automatic feeding.
 
(...) One way that I did this was to steal an idea from the railroad world. (...) In my case I put a conductor (a wire) around the outside of my two drive wheels. At the top of the wheels was a 'brush' (which was a simple spring loaded contact) and (...) (30 years ago, 15-Feb-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR