To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *14351 (+5)
  Re: before I reinvent the wheel
 
No, but I have used my HP48sx to control the Fascinating Electronics board as well as an NRD535 shortwave receiver. The serial I/O of the HP48 is limited to shield, ground, tx and rx pins so in both cases I had to wire special cables to jumper (...) (27 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
 
  OVER 1 AMP
 
Now, I recieved two good answers for my problems. 1) Built an H-Bridge 2) Use the LMD18200 Now has any one any documentation on an easy H bridge that I could build without wasting much time? The same goes for the LMD18200, I understand that is not (...) (27 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
 
  Re: OVER 1 AMP
 
(...) www.yahoo.com, search for "H Bridge", trust me, lots of hits will comeup. Look for the 4QD pages, they talk a lot about H Bridge designs. If you aren't comfortable with electronic design, don't bother though... (...) This IS an H Bridge. Its a (...) (27 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
 
  Re: OVER 1 AMP
 
Dear Paul, I have an H-bridge that I designed to run big motors. It runs at two amps continuous, and three amps intermittantly. It uses 5 volts for logic from your Handyboard, and 12 volts from a gel cell to run the motors. It also has an analog (...) (27 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
 
  NQC mentioned in Swedish technical weekly!
 
Hello! When reading this week's 'Ny Teknik' (New Technic), a weekly magazine for engineers, I found a short note about NQC. The article is about Lego Mindstorms, which is just about to be released here in Sweden, and the last part of the article (...) (27 years ago, 23-Sep-99, to lugnet.robotics, lugnet.robotics.rcx.nqc)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR