To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *14321 (+5)
  Re: a couple of new-bot questions from a generally quiet lurker
 
(...) You can achieve all 5 of these criteria with the standard differtrans, if you put a rotation sensor directly on each motor shaft... [ I've build such a 'bot, and it appears to work pretty well (ie it measures distance accurately, and drives in (...) (27 years ago, 21-Sep-99, to lugnet.robotics)
 
  Shaft encoder
 
To anybody, I have build a shaft encoder. Where can I get the software driver to evaluate the encoder data? Thanx, Jens (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
 
  OVER 1 AMP
 
Thanks everyone for your help, Now, I recieved two good answers for my problems. 1) Built an H-Bridge 2) Use the LMD18200 Now has any one any documentation on an easy H bridge that I could build without wasting much time? The same goes for the (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
 
  OVER 1 AMP
 
Oh yeah, one more thing, how about connecting a 5 ohm resistor in series with a DC motor and there are 2 amps flowing, then the resistor is dissipating 20 watts of heat. Now I could have a higher value for the resistor, like 7, 10 ohms, I think that (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
 
  RE: OVER 1 AMP
 
You can also stack a few of the original chips to make em work in parrallel. (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR