To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *14321 (+10)
  Re: a couple of new-bot questions from a generally quiet lurker
 
(...) You can achieve all 5 of these criteria with the standard differtrans, if you put a rotation sensor directly on each motor shaft... [ I've build such a 'bot, and it appears to work pretty well (ie it measures distance accurately, and drives in (...) (27 years ago, 21-Sep-99, to lugnet.robotics)
 
  Shaft encoder
 
To anybody, I have build a shaft encoder. Where can I get the software driver to evaluate the encoder data? Thanx, Jens (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
 
  OVER 1 AMP
 
Thanks everyone for your help, Now, I recieved two good answers for my problems. 1) Built an H-Bridge 2) Use the LMD18200 Now has any one any documentation on an easy H bridge that I could build without wasting much time? The same goes for the (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
 
  OVER 1 AMP
 
Oh yeah, one more thing, how about connecting a 5 ohm resistor in series with a DC motor and there are 2 amps flowing, then the resistor is dissipating 20 watts of heat. Now I could have a higher value for the resistor, like 7, 10 ohms, I think that (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
 
  RE: OVER 1 AMP
 
You can also stack a few of the original chips to make em work in parrallel. (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
 
  Re: Shaft encoder
 
(...) The shaft encoder library routine available from the Handy Board web site works great for me. Just follow the links to Software, then Libraries, then Shaft encoders. Good luck! -- Will , , __@_/ \_@__ |/ | /__, o @_/ )\ ) ( \ (\/\\, ~~~...~~~ (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
 
  (canceled)
 
 
  IR prox detector with robolab?
 
Has anyone made a sort of IR proximity detector, using the built-in IR transmitter/detector and robolab? Or have they all been made with NQC? (27 years ago, 21-Sep-99, to lugnet.robotics)
 
  Using 12V supply with Expansion Board?
 
Hello 'Botter, I think I am about to ask a stupid question but as a precaution, will the Expansion board be "ok" with a new 12V motor supply rather than the 9.6V connected to the Power Expansion header (J13)on the HB since the Expansion board and HB (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
 
  Re: Web site update
 
More updates.... I have redesigned the Touch Sensor made from old Mouse parts: (URL) now has a longer 'throw' (button travel distance) and uses elec. connection wires instead of screws. -Wes (27 years ago, 21-Sep-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR