To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *12861 (+5)
  Lego Scanner - DTM
 
Hi all. I have pics and info of my latest creation - A Lego Scanner (~25 dpi) I like to call DTM (Digital Terrain Modeller). To see it go to www.astolfo.com/lego and go to the Mindstorms section. CIAO (27 years ago, 26-Jul-99, to lugnet.robotics)
 
  Zapped Firmware
 
-Apparently I have twice erased my firmware by putting a heavy load on motors attached to the RCX. The batteries do not appear to be dead. Is this normal behavior? -JW Jonathan Woodward woodward@guesswork.com (URL) find your (...) (27 years ago, 26-Jul-99, to lugnet.robotics)
 
  Re: Weak Motor
 
(...) It wouldnt be wise to directly connect your 12V supply to the Handy Board... even if it doesnt cause damage to your Handy Board, I dont think your motor will be able to draw sufficient current from the motor port to run properly. Rather, you (...) (27 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
 
  Temperature Sensor
 
Does anyone know the exact characteristics of Lego's temperature sensor? It's easy enough to buy a thermistor and hook it up, but I'd like the temperature readings to be accurate. I've seen thermistors described by a resistance at 25 degrees C and a (...) (27 years ago, 26-Jul-99, to lugnet.robotics)
 
  Interfacing handyboard with Basic Stamp2
 
Hello to everybody. I would like to ask if is possible to interface the handyboard with the basic stamp2 using not the RS232. Thanks beforehand. (27 years ago, 26-Jul-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR