 | | speed control help
|
|
I have a problem that involves speed control. My robot is curently configured for differential steering and have shaft encoders installed on each one for feedback. the shaft encoders generate 64 pulses /rev The motors are PWM using the rug warrior (...) (27 years ago, 23-Jun-99, to lugnet.robotics.handyboard)
|
| |
 | | Paris, Rome, & Rolykits : )
|
|
In article <37705837.D413A8C6@uswest.net>, Michael Aaron Finch <goblintrain@uswest.net> writes (...) They're a bit far south to see the eclipse, and it would be apity to be so close and miss it. Go to Metz (France), and see both the hot air ball0on (...) (27 years ago, 23-Jun-99, to lugnet.robotics)
|
| |
 | | RE: signals / legOS internals
|
|
(...) Not to put too fine a point on it, and I hope Kekoa agrees, but the "fluff" is the reason why replacement firmware works in the first place. Without the ROM vectors being dispatched through RAM pointers that are initialized by the ROM and then (...) (27 years ago, 23-Jun-99, to lugnet.robotics.rcx.legos)
|
| |
 | | Lego Reflectivity in the IR Band
|
|
-In case you were curious about which colors of Lego reflect infrared the best, I did a little experiment. Visit my Lego page at: (URL) -JW Jonathan Woodward woodward@guesswork.com (URL) don't know which is more depraved: The audacity and greed (...) (27 years ago, 23-Jun-99, to lugnet.robotics)
|
| |
 | | Re: signals / legOS internals
|
|
(...) Actually, gcc moves the stack pointer before using any variables, so it is always safe to use stack below the current stack pointer. If you are using a different C compiler or doing assembly tricks, then you are on your own. (...) Traditional (...) (27 years ago, 23-Jun-99, to lugnet.robotics.rcx.legos)
|