 | | Problems with Macintosh and Robolab
|
|
---...--- Problems with RCX and ROBOLAB for Macintosh ---...--- I can't get any communication from Macintosh to RCX. The RCX and the IR-tower are okay - the connection from a Windows98-PC to RCX shows no errors. Trying any port (modem or printer) I (...) (27 years ago, 21-May-99, to lugnet.robotics)
|
| |
 | | Sony Robotic Dog: Check it Out!
|
|
(URL) it out. The robot learns from experience. It can also be programmed to exhibit new behaviors. Ross M. Tonkens, M.D. Medical Director Primary Care of Nevada 100 North Green Valley Parkway Suite 240 Henderson, NV 89014 702 914-7120 VOICE 702 (...) (27 years ago, 23-May-99, to lugnet.robotics)
|
| |
 | | Re: Windows CE
|
|
I think the best way would be to port NQC, Dave Baum makes the source freely available. (...) -- Did you check the web site first?: (URL) (27 years ago, 24-May-99, to lugnet.robotics)
|
| |
 | | Re: Problems with Macintosh and Robolab
|
|
I don't think speed is a problem. I was running an early version of Robolab on a 604e/132MHz. It was annoyingly slow to use, but it was able to talk with the RCX. You may want to try the IR tower in both "near" and "far" modes (that's the switch on (...) (27 years ago, 24-May-99, to lugnet.robotics)
|
| |
 | | Fwd: Re: Problems with Macintosh and Robolab
|
|
Hallo Dan, yes, I have already updated the serial drivers - without any result. NQC connects fine but not ROBOLAB. I wanted to try iconic programming with ROBOLAB. Ralf (...) to (...) robolab (...) try (...) --- Sent through Global Message Exchange (...) (27 years ago, 24-May-99, to lugnet.robotics)
|