To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *11761 (+10)
  withdraw
 
Dear Sir, Please take from the list. Thanks for all, Jorge (27 years ago, 22-May-99, to lugnet.robotics.handyboard)
 
  RE: withdraw?
 
I'm not sure how "signatures" work, but maybe one could be added to every handyboard message reminding people of the proper procedure on how to take themselves off the mailing list? Just a suggestion! Dave (27 years ago, 22-May-99, to lugnet.robotics.handyboard)
 
  L.A. Store
 
Hi Does anybody know about a electronic or robotic store at L.A. (Los Angeles).? And the Address. Please Thanks Daniel ---...--- " `BETTER´ IS THE ENEMY OF `GOOD ENOUGH´" ---...--- (27 years ago, 22-May-99, to lugnet.robotics.handyboard)
 
  Using SPI
 
I am using the SPI port to communicate with another Handy Board. I have written a routine in IC that will pass bytes between controllers just as it is supposed to work. However, the code is not very clean and it is very touchy. Change one thing and (...) (27 years ago, 22-May-99, to lugnet.robotics.handyboard)
 
  Re: New creations: VCR and Car
 
(...) It's an Olympus D220L, pretty basic but it does the job. Sometimes I wish it was a little less wide-angle, but otherwise good. (...) Yes it does, but not so you'd notice. I messed around with it to get the steering link at the right height to (...) (27 years ago, 22-May-99, to lugnet.robotics)
 
  Re: New creations: VCR and Car
 
Fredrik Glöckner wrote in message ... (...) And I use Larry the same way. Moz (27 years ago, 22-May-99, to lugnet.robotics)
 
  Re: New creations: VCR and Car
 
(...) And we're all happy. ;-) Fredrik (27 years ago, 23-May-99, to lugnet.robotics)
 
  More about problems with RCX and ROBOLAB for Macintosh
 
---...--- More about problems with RCX and ROBOLAB for Macintosh ---...--- I can't get any communication from Macintosh to RCX with the ROBOLAB software. The RCX and the ir tower are okay - the ROBOLAB connection from a Windows98 pc to RCX shows no (...) (27 years ago, 23-May-99, to lugnet.robotics)
 
  Midi?
 
Hi Folks, I was wondering if anyone had any code to input/output Midi from the Handyboard? Thanks, Chris Prosser (27 years ago, 23-May-99, to lugnet.robotics.handyboard)
 
  Re: Midi?
 
(...) Chris, check: (URL) is a midi library for the Hb here. Best, Duncan (27 years ago, 23-May-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR