To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *11041 (+5)
  IR test reports "Rubbish" when I run test.c
 
When I try to get the values for my IR transmitter the test.c reports that it is a bad. It calls it 'rubbish' why would that be? -Peter (28 years ago, 23-Apr-99, to lugnet.robotics.handyboard)
 
  Re: handyboard clock speed
 
(...) From the data books for the 68HC11, if you have any version of the E-series (except for perhaps one, a low-power version?), you can run them at up to a 3MHz E-clock (12MHz crystal). I haven't looked at the rest of the handyboard schematic with (...) (28 years ago, 23-Apr-99, to lugnet.robotics.handyboard)
 
  Re: legOS Network Protocol
 
(...) given (...) lego (...) [ stuff about lego/native collisions ] (...) of a (...) on (...) I was wondering, since people are considering using tags in the LNP frame to signify local to local messages, could we not also use this to "label" non (...) (28 years ago, 23-Apr-99, to lugnet.robotics.rcx.legos)
 
  Re: handyboard clock speed
 
(...) yes, this is right. the fastest you can go with the 52-pin 6811s is 12 MHz crystal --> 3 MHz system clock (i'm pretty sure). so this is only 1.5x over the stock HB. so you've got the issue Curt pointed out with not only the downloader, but (...) (28 years ago, 23-Apr-99, to lugnet.robotics.handyboard)
 
  Re: handyboard clock speed
 
(...) Not going to mention the free Otto/Steven/Keith/Curt GCC-2.8.1 HC11 port? I'm hurt. ;-) Maybe you need to add my web & ftp pages to your free software page, now that I have a GCC Handyboard library available? GCC/HC11 patches are available (...) (28 years ago, 23-Apr-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR