To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *10741 (+5)
  Re: **lego motors?**
 
(...) I don't think that it would take up a lot of space at all. In fact, the largest part should be the motor that is used to engage/disengage the gear. Using a tractor hub, two 16-T gears, and two axles (with other parts to hold this all together, (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Re: **lego motors?**
 
Laurentino Martins wrote in message <4.1.19990412164203....90.220>... (...) gears, with a rubber band pushing it to one of the sides...? There has been a couple of versions of just what you describe, however I don't have the URLs. Sorry... about (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  just to say hi
 
hi (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Has anyone an icb-routine for 9600b serial connection ?
 
Hi, i used the serialio.c routines to establish a data connection between the Handyboard and a Linux PC and encountered the same problems already mentioned in the mailing list: 1) Only char by char transmission with sleeps between transmissions (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: SENSOR_READ doesn't return 0
 
(...) I am just dabbling at the moment, trying a few words to try and get them debugged. In order to fully port the SpeedBot (currently in NQC) I'll need multitasking... (...) Oh, good - I wondered if I'd got versions mixed up somewhere. It would be (...) (28 years ago, 13-Apr-99, to lugnet.robotics.rcx.pbforth)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR