 | | Re: Increasing current output to motors on HandyBoard
|
|
So that's like $28 for the H excluding the protecting circuitry? How much did this setup cost for both motors? ---...--- ericson mar Robotics Consultant mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the (...) (28 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Quick troubleshooting help please!!!!
|
|
I would also check the circuit traces. Clip an ohm meter to the battery ground and check all the ground points, then do the same for +battery. Take a magnifying glass to the traces you can see. Look for places where the smoke got out. Once the (...) (28 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Increasing current output to motors on HandyBoard
|
|
Total cost for both, $56.00. Smaller ones are cheaper. Again, the advantage is convenience, not cost. These pulg right into the motor driver output ports on either the Handy Board or the Rug Warrior with the L293D left in place, and take no other (...) (28 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | multitasking
|
|
I have a simple question regarding multitasking. I am using two subroutine in a multitasking. start_process(ir()); start_process(detect()); Both subroutine should run for 5 ms(default). Consider an example that the subroutine detect() require more (...) (28 years ago, 11-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | Non-Lego mechanics reference / New Ideas?
|
|
Hi all, Has anyone come across any good basic mechanical reference resources? I have found that patent searches are a tad more complex than what I am looking for. I would be interested in hearing about non-Lego reference sites (or books!!)that cover (...) (28 years ago, 11-Apr-99, to lugnet.robotics)
|