Subject:
|
Re: New Parts Drawings - Plates, Slope, Track Pieces
|
Newsgroups:
|
lugnet.parts.custom
|
Date:
|
Sat, 5 Feb 2005 00:08:17 GMT
|
Viewed:
|
7926 times
|
| |
|
|
The piece I really want is 2x5 or 1x5 (or x7) bricks and plates. When building
a MOC that’s an odd number of studs wide, you have to either make it
asymmetrical or use x1 and x3 bricks which aren’t good for structural support.
|
|
Message has 1 Reply:
 | | Re: New Parts Drawings - Plates, Slope, Track Pieces
|
| (...) I've always found it interesting that 1x3 and 2x3 bricks and plates are the only odd length elements of those general categories. As you mention, there's no 1x5, no 2x5, no 1x7, no 2x9 and so on. I assume this is by design, but then you have (...) (20 years ago, 5-Feb-05, to lugnet.parts.custom, FTX)
|
Message is in Reply To:
| | New Parts Drawings - Plates, Slope, Track Pieces
|
| I wish TLC would make these parts. Seeing earlier discussions I think I'm not alone! I've attempted 3rd angle projection drawings, showing top, side and underside, despite not having a drawing package. Drawing these parts in Paint is eyestrain city! (...) (20 years ago, 2-Feb-05, to lugnet.parts.custom, lugnet.trains, lugnet.dear-lego, lugnet.general, lugnet.lego, FTX) !!
|
21 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
