Subject:
|
Re: New Parts Drawings - Plates, Slope, Track Pieces
|
Newsgroups:
|
lugnet.parts.custom
|
Date:
|
Thu, 3 Feb 2005 21:33:38 GMT
|
Viewed:
|
7721 times
|
| |
|
|
| |
Another time, I might draw a few of the parts that I’ve made from existing
ones - the tried and tested selection!
PLMKWYT
Mark
|
Very cool--I’ll take those over new Bionicle parts any day. I can see the
victorian porches now with that sloped brick...
I wonder if you could add this to your part list, I was just thinking about this
yesterday...here’s what I had--I can only go via description here.
First, you have this part:
www.peeron.com/inv/parts/6215 (2x3 brick with curved top)
Now, could this part:
www.peeron.com/inv/parts/3675
be modified to a rounded curve instead of a 33 degree slope?
The idea, instead of using a 33 degree corner slope, have a corner more
rounded--looks more like those aluminum awnings used on older homes.
-Scott Lyttle
|
|
Message has 1 Reply:
 | | Re: New Parts Drawings - Plates, Slope, Track Pieces
|
| (...) OK, so the piece is like this: 1. The base is 3x3. 2. Is the corner a right angle, an 8mm radius curve, or a 16mm radius curve, like this piece? (URL) 3. I assume it has 2x2 studs on top, as if two 2x3s with curved top had been superimposed at (...) (20 years ago, 4-Feb-05, to lugnet.parts.custom, FTX)
|
Message is in Reply To:
| | New Parts Drawings - Plates, Slope, Track Pieces
|
| I wish TLC would make these parts. Seeing earlier discussions I think I'm not alone! I've attempted 3rd angle projection drawings, showing top, side and underside, despite not having a drawing package. Drawing these parts in Paint is eyestrain city! (...) (20 years ago, 2-Feb-05, to lugnet.parts.custom, lugnet.trains, lugnet.dear-lego, lugnet.general, lugnet.lego, FTX) !!
|
21 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
