 | | Re: need to make a 15 degree angle —Brian Davis
|
| | | (...) Well... as a Technic type, I'd do that with triangles. A long Technic beam as the base, and another almost-as-long for the slope, with a small beam for the "back" or "support" - since you can join these by pins, the geometry is rather (...) (16 years ago, 1-Oct-08, to lugnet.parts)
|
| | | |
| | | | | Re: need to make a 15 degree angle —Sam Pagel
|
| | | | (...) It doesn't need to be exact, just repeatable. I need to make an armature of 4 or 5 successive 15degree "turns" to support some panels that are making sort of a jointed arc. I'll give the technic pieces a try. Almost jumped for joy at Nick (...) (16 years ago, 1-Oct-08, to lugnet.robotics)
|
| | | | |
| | | | | | Re: need to make a 15 degree angle —Nick Kappatos
|
| | | | (...) Further measurements show that connector #3 is 22.5 degrees - this means you can use these to make a jointed 90 degree arc with 5 panels (the ends would be perpendicular to each other). Would this meet your design requirement? (16 years ago, 2-Oct-08, to lugnet.robotics)
|
| | | | |
| | | | | | Re: need to make a 15 degree angle —Sam Pagel
|
| | | | (...) The arc in question only covers 75degrees (5 panels, the first starting at a 15 degree angle). i managed to make it effectively with the suggestion of triangles out of technic pieces. triangles made of two 1X6 technic bricks and one 1X2 brick (...) (16 years ago, 2-Oct-08, to lugnet.robotics)
|
| | | | |
