|
|
 | | Re: Which glue?
|
| (...) There is of course an alternative, if you want to put up with the hassle. Buy a good respirator with a cartridges designed to filter out the MEK. But you need to be careful. You need to make sure that the cartridges are fresh as once in use (...) (17 years ago, 23-Feb-08, to lugnet.parts.mod, FTX)
| | | | | Re: Which glue?
|
| (...) Im starting to wonder if Brian is taking up glue sniffing as a new hobby, WINK! Actually, you have my interests peaked as well... not planning a GARF (1), are you? Janey "Plays Lego at room temps, Red Brick" 1. Great Alaska Robot Fest (17 years ago, 23-Feb-08, to lugnet.parts.mod)
| | | | | Re: How do -you- clean your LEGO parts?
|
| (...) The same way you dust them - blast the crevices with canned air. This can be expensive given that canned air is not cheap and bricks will go flying if you don't hold them down, but it's fast and easy. EJP (17 years ago, 23-Feb-08, to lugnet.parts, FTX)
| | | | | Re: How do -you- clean your LEGO parts?
|
| (...) I run them in the dishwasher, on the top rack in mesh bags. I even use the heat. It's never been a problem. To dry the bricks, I put them in the food dehydrator. It's one of those stackable models with a big pile of trays. I distribute the (...) (17 years ago, 23-Feb-08, to lugnet.parts, FTX)
| | | | | Re: Which glue?
|
| (...) I saw that today while shopping the adhesives section of Lowe's, but didn't end up getting it (I may yet, depending on how tests go). Curiously when I mention the temperature requirement, the helpful salesperson almost laughed out loud :-). (...) (17 years ago, 22-Feb-08, to lugnet.parts.mod)
|
|
