Subject:
|
Re: How do -you- clean your LEGO parts?
|
Newsgroups:
|
lugnet.parts
|
Date:
|
Sat, 23 Feb 2008 03:11:31 GMT
|
Viewed:
|
7933 times
|
| |
|
|
In lugnet.general, Jordan Bradford wrote:
| |
How do you dry them after they’re cleaned? Water usually stays trapped in the
small crevices because of surface tension and takes forever to evaporate. This
can also leave soap marks.
|
The same way you dust them - blast the crevices with canned air. This can be
expensive given that canned air is not cheap and bricks will go flying if you
don’t hold them down, but it’s fast and easy.
EJP
|
|
Message is in Reply To:
 | | How do -you- clean your LEGO parts?
|
| I don't think LUGNET has had any discussions about this in quite some time. How do -you- clean your LEGO parts? I'm interested in learning people's techniques, particularly ones that clean a lot of parts at once with little effort. LEGO that's been (...) (17 years ago, 21-Feb-08, to lugnet.general, lugnet.parts)
|
9 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
