Subject:
|
Re: GBC Questions
|
Newsgroups:
|
lugnet.org.us.laflrc
|
Date:
|
Wed, 28 Sep 2005 19:28:04 GMT
|
Viewed:
|
908 times
|
| |
|
|
In lugnet.org.us.laflrc, David Koudys wrote:
> You don't find that having one motor port powering
> the entire track to be hard on the RCX?
Not so far - both Steve & I have run numerous hours of GBC trains (engine
plus a couple cars) from a 1.0 RCX. I only noticed two issues: (1) the output
area of the RCX does get slightly warm, at least on mine, but never shut down
due to thermal issues, and (2) if you forget to turn out the powerstrip feeding
power into a 1.0 RCX, it will run the train... slooowly... until it pulls too
much current, and corrupts the firmware.
--
Brian Davis
|
|
Message has 1 Reply:
 | | Re: GBC Questions
|
| (...) I've had the same thing hapen when I'm using LDCC--'Whys the train moving slow??' <beep beep!> 'Rats! Reload the firmware...' Dave K (19 years ago, 28-Sep-05, to lugnet.org.us.laflrc)
|
Message is in Reply To:
| | Re: GBC Questions
|
| In lugnet.org.us.laflrc, Steve Hassenplug wrote: <snip> (...) Thanks for telling--mucho appreciated. You don't find that having one motor port powering the entire track to be hard on the RCX? Dave K (19 years ago, 28-Sep-05, to lugnet.org.us.laflrc)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
