 | | Just a few highlights and points...
|
| No, I've still not made a LIDAR webpage for the site (I'm also considering a line-following page - Steve, I know you wanted to do that at one time on your site). But a few posts on LUGNET caught my eye: (URL) ran it through (URL) for a (...) (21 years ago, 27-Sep-05, to lugnet.org.us.laflrc)
| | | | | Re: LafLRC @ IndyLUG
|
| (...) I just set-up the train loop on my table at home. It's actually pretty small. The whole GBC pictured above will be moved 1 baseplate towards the left (front). The train will not run right against the back of the GBC. It will be 8 studs away. (...) (21 years ago, 27-Sep-05, to lugnet.org.us.laflrc)
| | | | | Re: LafLRC @ IndyLUG
|
| (...) Ok, I just updated the layout, and put it on the front page of LafLRC.org I also figured out how to map directories (or something like that), so you can see the GBC page at laflrc.org/GBC Steve (21 years ago, 26-Sep-05, to lugnet.org.us.laflrc)
| | | | | Re: LafLRC @ IndyLUG
|
| (...) No. Kerby's module is not 3x1, as shown. It's 2x2. Steve (21 years ago, 26-Sep-05, to lugnet.org.us.laflrc)
| | | | | Re: LafLRC @ IndyLUG
|
| (...) Looking at this layout,should I modify my 2-baseplate module so that it dumps at a right angle? I don't see a straight 2-BP section that is unassigned. It would be a really easy deal to modify my module so it dumps at a right angle and would (...) (21 years ago, 26-Sep-05, to lugnet.org.us.laflrc)
|
|
