Subject:
|
Re: Module Question?
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Sat, 30 Jun 2001 05:30:48 GMT
|
Viewed:
|
703 times
|
| |
|
|
In lugnet.org.ca.rtltoronto, Jeff Van Winden writes:
> I just purchased some the remaining baseplates for my first 3 modules....
> But I had a quick question, What is a good way to attach the plates to the
> modules, so that you can remove them (at a later date) and leave the plates
> in good condition? (no sticky stuff on the bottom (and I am not referring to
> oily tiers.....))
I originally thought thin tape. But once I started building, since I had
joined the baseplates together with a single 2x4 in the corner, the sheer
weight of the structures has held the reasonably in place.
I'll probably try thin tape. I need to experiment. However, I'm probably
going to build a frame to hold two modules one on top of each other, then
cardboard around the sides to prevent losing pieces. This might mean I
might not tape them.
Calum
|
|
Message is in Reply To:
 | | Module Question?
|
| Hi guys.... I just purchased some the remaining baseplates for my first 3 modules.... But I had a quick question, What is a good way to attach the plates to the modules, so that you can remove them (at a later date) and leave the plates in good (...) (23 years ago, 29-Jun-01, to lugnet.org.ca.rtltoronto)
|
4 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
