To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.org.ca.rtltorontoOpen lugnet.org.ca.rtltoronto in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Organizations / Canada / rtlToronto / 13730
  Re: RC racing track width
 
(...) That's a good question. I'm used to races based on time, not laps, but it doesn't mater either way. I would think around 10 would be good. (...) I don't think we need any serious restrictions... (...) Except of course this car. Otherwise I'm (...) (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
 
  Re: RC racing track width
 
(...) Haha, you said "Derek" -Rob (watching too many SImpsons reruns) A. (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
 
  Re: RC racing track width
 
(...) The only restrictions are: -Made of Lego, usual rtlToronto building requirements -uses the 8475/8366 Racer controller/receiver pair (ie, not the new outdoor RC or the old 5600 RC) That's about it. (...) I always wanted to get into RC, sigh. (...) (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
 
  Re: RC racing track width
 
(...) Man I don't know how I managed that one. I mean I am dyslexic, but I've never gotten anything that far out of whack before and not noticed it. Derek (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
 
  Re: RC racing track width
 
In lugnet.org.ca.rtltoronto, Calum Tsang wrote: <snip> (...) Dave K (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
 
  Re: RC racing track width
 
(...) I'll attempt to write a timing and scoring application like I did for C$. If I don't get it done a traditional lap sheet and pencil will do. Derek (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
 
  Re: RC racing track width
 
(...) Ok, so before I answer this, I would need to know when it is? Probably discussed at dinner, but since I was not there.... Jeff VW (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR