Subject:
|
Re: What is the best way to open a box?
|
Newsgroups:
|
lugnet.market.theory
|
Date:
|
Tue, 25 Jan 2000 18:25:15 GMT
|
Viewed:
|
610 times
|
| |
|
|
In lugnet.market.theory, Tyler Nagel writes:
> What is the best way to open a box so that it maintains it's value? Do you
> get out an xacto knife and cut along the seams, or do you just jump in and
> punch through the perferated semicircle on the back of the smaller boxes?
>
> Tyler Nagel
> tnagel@cadvision.com
I always slide a short thin knife underneath that semicircle and run it the
length of that edge, trying to separate that glue seal without damaging the
two cardboard flaps that the glue is holding together.
-Adam
|
|
Message is in Reply To:
 | | What is the best way to open a box?
|
| What is the best way to open a box so that it maintains it's value? Do you get out an xacto knife and cut along the seams, or do you just jump in and punch through the perferated semicircle on the back of the smaller boxes? Tyler Nagel (...) (25 years ago, 25-Jan-00, to lugnet.market.theory)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
