General Discussion : 53563


General / 53563	53562 \| 53564

Subject:	Re: A few ways to use old skeleton arms!
Newsgroups:	lugnet.parts, lugnet.general
Date:	Mon, 14 May 2007 13:14:01 GMT
Viewed:	774 times

In lugnet.parts, David Simmons wrote:

Hey all,

While building my ZombieTron, I discovered these two fits for loose old skeleton arms.

Dave S.

I’ve had arms slip into the 1x1s before, but they seemed rather loose. Do they hold inside the pin connector any better?

Jeff

Message has 1 Reply:

		Re: A few ways to use old skeleton arms!
(...) Indeed, the fit in the 1x1's is loose (my guess is it varies by arm), but the fit in the Technic cylinder is nice and tight! Dave S. (18 years ago, 16-May-07, to lugnet.parts, lugnet.general, FTX)

Message is in Reply To:

		A few ways to use old skeleton arms!
Hey all, While building my ZombieTron, I discovered these two fits for loose old skeleton arms. (URL) Dave S. (18 years ago, 13-May-07, to lugnet.parts, lugnet.general, FTX)

3 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search