Subject:
|
Re: Building help for set 392 Formula 1 racer
|
Newsgroups:
|
lugnet.general
|
Date:
|
Sun, 7 Jan 2007 04:51:17 GMT
|
Viewed:
|
1796 times
|
| |
|
|
Dave,
It looks to me as if that stack of 1x2, 1x2, 1x1 are centered on the
back 2x3 plates (top and bottom) of the intake scoop, so simply close
off the rear of the scoop. As to why they used a 1x1 on the top (or
didn't just use a 1x1 or 1x2 brick), I have no idea.
D. Shifflett wrote:
> Hi all,
> I just received a set 392 Formula 1 racer.
>
> I need help interpretting one step of the instructions.
> See http://www.peeron.com/scans/392-1/7
>
> In the inset box there are 2 blue 1x2 plates stacked up
> with a blue 1x1 plate on top of them.
> Those 3 pieces look to be part of the 'blower' being assembled
> in the inset box, but don't appear when the blower
> is installed on the top of the engine.
>
> Also the photos of the model dont show the back of the 'blower'
> but do show the top and those parts are not included.
> If they were the top of the 'blower' would be a 3x4
> with 1 more stud in the center of the back (5th row)
> The photos show
> XXXX
> XXXX
> XXXX
>
> But with those parts in the 'blower' it should be
> XXXX
> XXXXX
> XXXX
>
> Any help you can give me would be appreciated,
> Keep on bricking,
> dave
--
Tom Stangl
* http://www.vfaq.com/
* DSM Visual FAQ home
* 90 Talon AWD
* http://www.vfaq.net/
* Prius Visual FAQ Home
* 04 Prius AM #7
* 06 Prius NL #7
|
|
Message is in Reply To:
 | | Building help for set 392 Formula 1 racer
|
| Hi all, I just received a set 392 Formula 1 racer. I need help interpretting one step of the instructions. See (URL) the inset box there are 2 blue 1x2 plates stacked up with a blue 1x1 plate on top of them. Those 3 pieces look to be part of the (...) (18 years ago, 6-Jan-07, to lugnet.general)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
