Subject:
|
Re: Shining up Brasso'ed clear parts?
|
Newsgroups:
|
lugnet.general
|
Date:
|
Sun, 11 Nov 2001 13:24:01 GMT
|
Viewed:
|
1982 times
|
| |
|
|
In lugnet.general, Dave Johann writes:
> Solution: Water and a soft towel. It's worked wonders for all the large
> Blacktron II panels I needed to brasso down.
AAAAH! You Brasso(tm)ed Blacktron II panels??? You were joking, right? I'd
trade plain for printed in a heartbeat.
++Lar
|
|
Message has 2 Replies:
 | | Re: Shining up Brasso'ed clear parts?
|
| I guess I shouldn't mention that I plan to do this as well with the four extra panels I have. The hard part is getting three more of the trans-antifreeze giant 1/4 dome pieces from the Mega Core Magnetizer so I can make a complete dome. Dave "Larry (...) (23 years ago, 11-Nov-01, to lugnet.general)
| | | Re: Shining up Brasso'ed clear parts?
|
| (...) If I could have gotten plain Trans antifreeze panels, I wouldn't have felt the need to brasso the BTII ones. Unfortunately, most folks won't trade these easily. I wouldn't normally care, but it's the only large panel color I work with. Had I (...) (23 years ago, 12-Nov-01, to lugnet.general)
|
Message is in Reply To:
10 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
