Subject:
|
Re: Shining up Brasso'ed clear parts?
|
Newsgroups:
|
lugnet.general
|
Date:
|
Sat, 10 Nov 2001 07:25:23 GMT
|
Viewed:
|
2893 times
|
| |
|
|
In lugnet.general, David Simmons writes:
> Hey all,
>
> I recently worked off the printing on four of the trans-dark green 1/4
> saucer UFO pieces from the Insectoids Arachnoid Star Base. It worked well
> except I'm left with a slight pattern of whorls, much like fingerprints,
> which were created by the combination of mild Brasso abrasive and the cotton
> balls I used. I was thinking of using cotton balls with water to try to
> polish these whorls out. Has anyone else tried something similar and how
> did it work?
>
> Thanks in advance,
>
> Dave
Solution: Water and a soft towel. It's worked wonders for all the large
Blacktron II panels I needed to brasso down.
-Dave
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Shining up Brasso'ed clear parts?
|
| Hey all, I recently worked off the printing on four of the trans-dark green 1/4 saucer UFO pieces from the Insectoids Arachnoid Star Base. It worked well except I'm left with a slight pattern of whorls, much like fingerprints, which were created by (...) (25 years ago, 10-Nov-01, to lugnet.general)
|
10 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
