 | | Impossible to take apart - reprise
|
|
After enjoying the discussion about the hard-to-take-apart cube I thought about some constuctions myself. Couldn't come up with something simple and elegant so far, however....... I'm just after taking the 8448.... almost. In the door-opening (...) (23 years ago, 11-Jun-01, to lugnet.general, lugnet.technic)
|
| |
| | Re: Impossible to take apart - reprise
|
|
(...) I came across the same problem when I took my <set:8448> apart. I think "theoretically" it's not different from separating two plates - it's possible but sometimes the height of the plate does not provide a good grip and it's hard to apply (...) (23 years ago, 11-Jun-01, to lugnet.general, lugnet.technic)
|
| |
| | Re: Impossible to take apart - reprise
|
|
(...) Yes, that was a bit of a struggle, but try to stack two of the "Bracket 5 x 2 x 2&1/3" togheter so that the 2x3 "plates" connects and the 2x2 "plates" connect. They will be one stud offset. Hum, this came otu to be hard to describe. Just put (...) (23 years ago, 16-Jun-01, to lugnet.general, lugnet.technic)
|
| |
| | Re: Impossible to take apart - reprise
|
|
(...) I have had the exact same problem with that little assembly on the 8448 Super Street Sensation. Despite repeated attempts with pushing axle through the holes I have not been able to pull the two elements apart yet. It's too bad since I only (...) (23 years ago, 16-Jun-01, to lugnet.general, lugnet.technic)
|
