General Discussion : 18595


General / 18595	18594 \| 18596

Subject:	Re: Controller speed
Newsgroups:	lugnet.trains, lugnet.trains.org, lugnet.general
Date:	Tue, 30 May 2000 19:00:15 GMT
Viewed:	76 times

> This worked real well, fortunately no kids figured out to remove the pegs. > The did make the control a bit stiff to turn though, so I'm going to do some > more work to it so that little hands can turn it easier. Just go out and get a 6V wall wart, or a variable wall wart (from Radio Shack), then run it at a apropriate setting...if the voltage input is limited, then the output will be too... James P

Message has 1 Reply:

		Re: Controller speed
James, I don't know if it would be that simple since the voltage coming in is 9-12AC and then converted over to 9V DC. And the solution I used didn't cost me any money, and I always like those kind of solutions. ;) jt (...) Shack), (...) the (...) (24 years ago, 30-May-00, to lugnet.trains, lugnet.trains.org)

Message is in Reply To:

		Re: Pictures up from NGLTC Memorial Day display
That was the controller being used on the interactive kid track. Basically it was 6'x6' track that did a figure 8 and went up the mountain. The holes in the controller were put there by me so that I could regulate the max speed for the controller in (...) (24 years ago, 30-May-00, to lugnet.trains, lugnet.trains.org, lugnet.general)

15 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search