Subject:
|
Re: Ldraw - Runtime Error 200
|
Newsgroups:
|
lugnet.general
|
Date:
|
Fri, 10 Mar 2000 17:04:43 GMT
|
Viewed:
|
3759 times
|
| |
|
|
Thanks for the suggestion, but this does not solve the problem. Dennis
Selçuk Göre wrote:
> Dennis Osborn wrote:
> >
> > Hello All
> >
> > I downloaded ldraw.exe, complete.exe, and rte200fx.exe to my hard drive.
> >
> > I <start><run>
> > c:\ldraw.exe -y
> > c:\complete.exe -y
> > c:\rte200fx.exe <-- I do run the patch
> > c:\ldraw\mklist.exe
> >
> > Everything appears to expand and run correctly. But when I run
> > c:\ldraw\ledit.exe
> > I get the Runtime Error 200.
>
>
> Try once, but this time copy rte200fx to your Ldraw directory (C.\LDRAW\
> most probably), then rerun it. I think this would solve the problem.
>
> Selçuk
>
> > Any suggestions? I am running a Gateway GP6-450.
> > I read on ldraw.org that the patch was needed because 200mhz machines
> > were outracing a built in delay counter. Could my 450mhz machine be
> > ourtracing the patch?
> >
> > Dennis Osborn
> > osbodr01@holmes.ipfw.edu
|
|
Message has 1 Reply:
 | | Re: Ldraw - Runtime Error 200
|
| (...) Dennis - after you ran rte200fx in your c:\ldraw directory did you run the patch batch file - ldpatch.bat? This is what I had to do on my Gateway 600mhz to take care of the runtime error. Scott (27 years ago, 16-Mar-00, to lugnet.general)
|
Message is in Reply To:
| | Re: Ldraw - Runtime Error 200
|
| (...) Try once, but this time copy rte200fx to your Ldraw directory (C.\LDRAW\ most probably), then rerun it. I think this would solve the problem. Selçuk (...) (27 years ago, 10-Mar-00, to lugnet.general)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
