Subject:
|
Re: Ldraw - Runtime Error 200
|
Newsgroups:
|
lugnet.general
|
Date:
|
Fri, 10 Mar 2000 16:09:38 GMT
|
Reply-To:
|
SGORE@spamlessSUPERONLINE.COM
|
Viewed:
|
1081 times
|
| |
|
|
Dennis Osborn wrote:
>
> Hello All
>
> I downloaded ldraw.exe, complete.exe, and rte200fx.exe to my hard drive.
>
> I <start><run>
> c:\ldraw.exe -y
> c:\complete.exe -y
> c:\rte200fx.exe <-- I do run the patch
> c:\ldraw\mklist.exe
>
> Everything appears to expand and run correctly. But when I run
> c:\ldraw\ledit.exe
> I get the Runtime Error 200.
Try once, but this time copy rte200fx to your Ldraw directory (C.\LDRAW\
most probably), then rerun it. I think this would solve the problem.
Selçuk
> Any suggestions? I am running a Gateway GP6-450.
> I read on ldraw.org that the patch was needed because 200mhz machines
> were outracing a built in delay counter. Could my 450mhz machine be
> ourtracing the patch?
>
> Dennis Osborn
> osbodr01@holmes.ipfw.edu
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Ldraw - Runtime Error 200
|
| Hello All I downloaded ldraw.exe, complete.exe, and rte200fx.exe to my hard drive. I <start><run> c:\ldraw.exe -y c:\complete.exe -y c:\rte200fx.exe <-- I do run the patch c:\ldraw\mklist.exe Everything appears to expand and run correctly. But when (...) (25 years ago, 10-Mar-00, to lugnet.general)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
