To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.generalOpen lugnet.general in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 General / 1615
1614  |  1616
Subject: 
Re: Removing printing from lego parts
Newsgroups: 
lugnet.general
Date: 
Fri, 25 Dec 1998 00:38:45 GMT
Viewed: 
2690 times
  
Nick Chauvin writes:
> Do you hate the printing on the u.f.o parts?  Well I have used a technique
> from my years of scale modeling to remove stupid printing from Lego pieces.
> By using various grades of automotive sandpaper and Blue Magic metal polish. I
> buy it in the automotive section at Wal-Mart.  Begin by sanding away all of
> the offending paint with 800 grit, sand in one direction to minimize
> scratches. Do not sand too hard or else corners on canopies will become
> rounded. After all the paint is gone switch to 1000 grit sand in a circular
> motion until the previous scratches are gone. Use 2000 grit sandpaper in the
> same manner as the 1000 grit.  At this point you should have a smooth dull
> surface.  Then apply a few drops of the metal polish to the Lego and buff it
> in using a piece of an old t-shirt.  Use the Blue Magic in a ventilated area
> because it contains ammonia.  After four of five applications of polish the
> surface should shine like a brand new piece.  I have used this method on the
> u.f.o. pieces and several canopies.   Give it a try!

Very cool. . . now where did I put those Aquashark's stupid canopies??

Barry



Message has 1 Reply:
  Re: Removing printing from lego parts
 
(...) This may not work as well on translucent, as even though you get the surface to tactilely and reflectivly be the same, it may still be a bit fogged. Worth a shot though, and sure to work on solid color pieces. (28 years ago, 25-Dec-98, to lugnet.general)

Message is in Reply To:
  Removing printing from lego parts
 
Do you hate the printing on the u.f.o parts? Well I have used a technique from my years of scale modeling to remove stupid printing from Lego pieces. By using various grades of automotive sandpaper and Blue Magic metal polish. I buy it in the (...) (28 years ago, 25-Dec-98, to lugnet.general)

3 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR