Subject:
|
Re: Build on Badge at BrickFest PDX 2004
|
Newsgroups:
|
lugnet.events.brickfest
|
Date:
|
Fri, 30 Jan 2004 11:57:29 GMT
|
Viewed:
|
983 times
|
| |
|
|
In lugnet.events.brickfest, Ross Crawford wrote:
| |
In lugnet.events.brickfest, Ross Crawford wrote:
|
| |
| |
The bricks aren’t glued together, are they? I mean I can put them together
in a different pattern?
|
|
No, they’re not glued together. The magnet sticky that you are given has run
just a little bit wider than one brick is tall, though.
| |
Oh and is the black brick always un-printed? Or could it be printed depending
on affiliations etc?
|
For a standard badge, only 4 bricks are engraved. The black one is always the
one that isn’t if I am not greatly mistaken, I do not believe that it’s a user
definable option.
(Your badge form has 3 user definable lines, and one line is used to name the
particular BrickFest that the badge is for)
Hope that helps.
Larry Pieniazek
Expo Coordinator, BrickFest PDX 2004, February 13-15, 2004
ILTCO | MichLUG |
Milton Train Works™
See you in Portland! (Oregon, USA, Earth :-) )
|
|
Message has 1 Reply:
Message is in Reply To:
6 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
