| |
In lugnet.db.brictionary, Thomas Garrison writes:
> Reports are that set 8353 contains this piece
http://www.math.purdue.edu/~tgarriso/lego/scans/invPics/42003.jpg
> which is clearly related to the Technic Axle Joiner Perpendicular 3L
http://guide.lugnet.com/partsref/search.cgi?q=32184
> and the confusingly named and oriented Technic Axle Joiner Perpendicular
> 3 Long
http://guide.lugnet.com/partsref/search.cgi?q=32068
> What on Earth should this new one be called? Technic Axle Joiner
> Perpendicular 3L with 2 Holes makes some sense, but is wordy (and actually
> refers to 2 *pin* holes, although it is usually implicit in existing
> taxonomy that a hole not specified as "axlehole" is a pin hole).
>
> --
> TWS Garrison
> http://www.math.purdue.edu/~tgarriso/
> Remove capital letters in address for direct reply.
If we understand that the "perpendicular" in the title indicates that the axle
holes and pin holes are always at right angles, then I suggest:
32068 : Technic Axle Joiner Perpendicular 3L - Axle/-/Pin
32184 : Technic Axle Joiner Perpendicular 3L - Axle/Pin/Axle
42003 : Technic Axle Joiner Perpendicular 3L - Axle/Pin/Pin
Chris
|
|
Message has 1 Reply:
Message is in Reply To:
5 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
