To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.rayOpen lugnet.cad.ray in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Ray-Tracing / 973
  RE: "Sticker" images
 
(...) L3P output uses the exact same scale and coordinate system as LDraw, so to place the part, figure out where the center of the sticker should go (in LEdit, MLCAD, whatever). To scale the sticker, remember that there are 20 LDU per stud, and 8 (...) (23 years ago, 3-Sep-01, to lugnet.cad.ray)
 
  Re: "Sticker" images
 
(...) Cool, thanks. One thing I just thought of though... the sticker isn't rectangular, it actually would be an ellipse... does that make a difference? (23 years ago, 3-Sep-01, to lugnet.cad.ray)
 
  RE: "Sticker" images
 
(...) You can make the portion outside of the ellipse transparent by defining which color index should be transparent (in the POV image map declaration), or you can change the "clipped_by" to a cylinder instead of a box (might be easier/more (...) (23 years ago, 3-Sep-01, to lugnet.cad.ray)
 
  Re: "Sticker" images
 
(...) Cool. I will have to hack. I got the rectangular version to work! Axel's post and your hints did the trick. The sticker is scaled a bit smaller than it actually will be or else the rectanglue would go off the edge, but it looks great in the (...) (23 years ago, 3-Sep-01, to lugnet.cad.ray)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR