 | | Re: Free-Form Camera Positioning with MLCAD, L3P, and POV-RAY
|
|
(...) No, L3P uses the LDraw coordinate system. This was an important design goal. L2P (LGEO) uses its own coordinate system. Otherwise a good description. You might also want to tell about the QUAL and STUDS variables in the POV file, used for (...) (24 years ago, 24-Dec-00, to lugnet.cad.ray, lugnet.cad.mlcad)
|
| |
| | Re: Is there some pov-ray friendly version of car wash brush part? [DAT]
|
|
Michal Krbec wrote... (...) Unfortunately the 2473 brush uses lines. This is poor design, it should have used cylinders, which will look correctly if you zoom in. Does anyone know how to make the matrix for a 4-4cyli.dat with radius R and endpoints (...) (24 years ago, 24-Dec-00, to lugnet.cad.ray)
|
| |
| | RE: Urgent help with POV needed...
|
|
(...) I believe it did default to TGA (for version 3.0 maybe?) --Bram Bram Lambrecht bram@cwru.edu (URL) (24 years ago, 23-Dec-00, to lugnet.cad.ray)
|
| |
| | Re: Urgent help with POV needed...
|
|
Yes I seem to remember that one of the older versions created targas as output. I had a hard time converting them : ( "Dave Schuler" <orrex@excite.com> wrote in message news:G5zoq1.Huz@lugnet.com... (...) (24 years ago, 23-Dec-00, to lugnet.cad.ray)
|
| |
| | Re: Urgent help with POV needed...
|
|
(...) Did it at one time default to *.tga format? Some piece of software I've used did that, but I can't remember which one. Dave! (24 years ago, 22-Dec-00, to lugnet.cad.ray)
|
