|
|
 | | Re: zoom function
|
| yes that would be very nice. -- And they said 'Computers will never be in general use' "Bill Fitzgerald" <wfitz@ptway.com> wrote in message news:GEH3J9.HEF@lugnet.com... (...) from (...) part (...) (23 years ago, 5-Jun-01, to lugnet.cad.mlcad)
| | | | | zoom function
|
| Is there a way to set up MLCAD so that when I do a zoom in, say change from 100 percent view to 300 percent view, to have the view centered on the part that is currently selected? It is a minor thing, but something that i would like to be able to (...) (23 years ago, 5-Jun-01, to lugnet.cad.mlcad)
| | | | | Re: Differences between rotation points
|
| (...) from (...) library (...) rotation (...) That helps a lot. Thanks! Cheers, --Ryan (23 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
| | | | | Re: Maximum Coarse movement
|
| (...) Shure, I will take care on that. In the mean time you could move the part using the mouse and a small scale factor in the viewing pane. That should help a little bit. Michael (23 years ago, 30-May-01, to lugnet.cad.mlcad)
| | | | | Re: Differences between rotation points
|
| (...) - Part Origin, is the absolute zero (0,0,0) point of the part itself. - Part Center, is the computed center of the part (e.g. the part ranges from (-2, -2, -2) to (+4, +4, +4) so the computed center is (+1,+1,+1). - The part rotation point, is (...) (23 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
|
|
