| |
Michael Lachmann wrote:
> - Part Origin, is the absolute zero (0,0,0) point of the part itself.
> - Part Center, is the computed center of the part (e.g. the part ranges • from
> (-2, -2, -2) to (+4, +4, +4) so the computed center is (+1,+1,+1).
> - The part rotation point, is not defined for normal parts from the • library
> (not yet), but can be set for selfmade parts, or sub-models. In the • rotation
> dialog you can define a custom point, the first custom point is the part
> rotation point.
>
> If the rotation point is set to part rotation point, and the part has no
> such point, mlcad will default to part origin instead ...
That helps a lot. Thanks!
Cheers,
--Ryan
|
|
Message is in Reply To:
 | | Re: Differences between rotation points
|
| (...) - Part Origin, is the absolute zero (0,0,0) point of the part itself. - Part Center, is the computed center of the part (e.g. the part ranges from (-2, -2, -2) to (+4, +4, +4) so the computed center is (+1,+1,+1). - The part rotation point, is (...) (24 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
