Subject:
|
Re: 2x3 trapezoid
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Tue, 17 Apr 2001 10:58:56 GMT
|
Viewed:
|
2144 times
|
| |
|
|
Simon,
It's called a "Wedge 3 x 2 Left" or a "Wedge 3 x 2 Right". In MLCad, look
under "Other Parts" and "W".
-Andy Lynch
----- Original Message -----
From: "Simon Bennett" <simon.bennett@ntlworld.com>
To: <lugnet.cad.mlcad@lugnet.com>
Sent: Tuesday, April 17, 2001 5:47 AM
Subject: 2x3 trapezoid
> I cannot find a particular element in Partsref. I have looked under every
> possible name I think you could give it to no avail. It's the brick that is
> 3 long but 2 wide at one end and 1 wide at the other (which comes in left
> and right hand versions).
|
|
Message has 1 Reply:
 | | Re: 2x3 trapezoid
|
| (...) Thank you both very much, I must be cracking up as I was sure I had checked 'wedge', sorry to bother you. Psi (24 years ago, 17-Apr-01, to lugnet.cad.mlcad)
|
Message is in Reply To:
| | 2x3 trapezoid
|
| Hello I have just got myself set up with MLCAD and I am drawing up all the MOCs that I have been unable to break down due to not wishing to forget how to build them but I have run into a problem which I hope this is the right place to come for an (...) (24 years ago, 17-Apr-01, to lugnet.cad.mlcad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
