Subject:
|
Re: Rotation trouble
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Sat, 24 Mar 2001 20:10:08 GMT
|
Viewed:
|
2509 times
|
| |
|
|
Hey,
There should be some buttons with arrows going around axes. These
control
the rotation of an element around the x, y, and z axes. The degree of
rotation is determined by the grid icon. You can also edit the amount
of rotation by going to Settings->General->Change->Step,Grid,Snap.
I had problems similar to yours. I recommend that you play around with
the various toolbars to see what they do. Hope this helps.
Travis Dickinson
Duq wrote:
>
> Hi all,
>
> I'm pretty much new to MLcad, although I'm not quite new to the world of
> CAD. I had some trouble after rotating a part at 45deg. After that I
> couldn't get the rotation angle back to 90.... Pieces were rotating all over
> the place, but not at 90deg.....
> Am I missing something obvious here?
>
> Tips much appreciated,
>
> Duq
|
|
Message is in Reply To:
 | | Rotation trouble
|
| Hi all, I'm pretty much new to MLcad, although I'm not quite new to the world of CAD. I had some trouble after rotating a part at 45deg. After that I couldn't get the rotation angle back to 90.... Pieces were rotating all over the place, but not at (...) (24 years ago, 24-Mar-01, to lugnet.cad.mlcad)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
