|
|
 | | Re: Creating folders in ML CAD
|
| (...) group, (...) Ohhhh YESSS! That would allow me to create an FLL group, with subgroups for beams, bricks, sensors, gears, etc. to duplicate the inventory boxes I made for the kids. Then MLCAD would be something my team could use, rather than me (...) (24 years ago, 2-Dec-00, to lugnet.cad.mlcad)
| | | | | Report Generator | Pieces
|
| I noticed when running a piece report that it doesn't allow for pieces in sub parts. It might be nice to have an added column that shows the pieces in each sub part, then total the number of pieces in the overall model. In other words, if you have (...) (24 years ago, 1-Dec-00, to lugnet.cad.mlcad)
| | | | | Re: Creating folders in ML CAD
|
| (...) Two thoughts on groupings: 1. For the default groupings, read the parts list and create groups for all first-words (or use the 0 CATEGORY entries from the part-files). This creates some odd non-groups, but it's better (IMO) than going through (...) (24 years ago, 1-Dec-00, to lugnet.cad.mlcad)
| | | | | Re: Export Problems
|
| In lugnet.cad.mlcad, Michael Lachmann writes: <SNIP> (...) You are right, that doesn't work at all - no matter if the inputs are valid or not, both buttons do not work. Please type the paths in by hand until I release the fixed version 2.0 Thanks, (...) (24 years ago, 1-Dec-00, to lugnet.cad.mlcad)
| | | | | Re: Export Problems
|
| Ok, thanks for the tip - I will check that! Michael Jeff Boen <onyx@flash.net> schrieb in im Newsbeitrag: G4r5I8.Hx1@lugnet.com... (...) doesn't (...) (24 years ago, 1-Dec-00, to lugnet.cad.mlcad)
|
|
