Subject:
|
Re: ML-CAD 3.30 Problem while parts authoring
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Wed, 17 Feb 2010 01:39:58 GMT
|
Viewed:
|
13729 times
|
| |
|
|
In lugnet.cad.mlcad, Timothy Gould wrote:
> In lugnet.cad.mlcad, Bernd Broich wrote:
> > Hello Michael,
> >
> > I have a problem while parts authoring.
>
> Oh yeah. I encountered this one the other day too.
Have you been authoring parts again? I thought your therapist warned you about
that????
;)
ROSCO
|
|
Message is in Reply To:
 | | Re: ML-CAD 3.30 Problem while parts authoring
|
| (...) Oh yeah. I encountered this one the other day too. The angle gets set to a very large number. I believe that the normal/angle mapping only applies to rotations, not scaling and should be ignored when ||R||!=1. Tim (15 years ago, 16-Feb-10, to lugnet.cad.mlcad)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
