Subject:
|
Re: ML-CAD 3.30 Problem while parts authoring
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Tue, 16 Feb 2010 21:39:00 GMT
|
Viewed:
|
13789 times
|
| |
|
|
In lugnet.cad.mlcad, Bernd Broich wrote:
> Hello Michael,
>
> I have a problem while parts authoring.
>
> When I have insert a new primitive and changing the first time it's values,
> like the size, evrything works fine. But when I want to change the size or
> so again. Then the "position & orientation" window means:
> "please enter a number between -180 and 180".
>
> Here is a picture:
> http://www.bernd-the-brick.de/pics/ideen/ML-CAD-Problem.jpg
>
>
> I hope, there is a solution for this problem.
>
> Regards
> Bernd
Oh yeah. I encountered this one the other day too. The angle gets set to a very
large number. I believe that the normal/angle mapping only applies to rotations,
not scaling and should be ignored when ||R||!=1.
Tim
|
|
Message has 2 Replies:
 | | Re: ML-CAD 3.30 Problem while parts authoring
|
| (...) IMHO if the rotvector field is active when pressing OK, it should pop up that dialog (or maybe even ignore changes altogether and close the dialog - I do not know nor do I care) if |angle| > 180. Nowhere else. I'd personally want this be fixed (...) (15 years ago, 17-Feb-10, to lugnet.cad.mlcad)
|
Message is in Reply To:
| | ML-CAD 3.30 Problem while parts authoring
|
| Hello Michael, I have a problem while parts authoring. When I have insert a new primitive and changing the first time it's values, like the size, evrything works fine. But when I want to change the size or so again. Then the "position & orientation" (...) (15 years ago, 16-Feb-10, to lugnet.cad.mlcad)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
