Subject:
|
Re: *** Start celebrating .... NOW
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Fri, 27 Dec 2002 16:49:22 GMT
|
Viewed:
|
4783 times
|
| |
|
|
> Thanks for the pointers Fredrik, I'll check them out now. I've used your
> ldraw mode program to create flex hoses in the past with no problems, it's
> just this new way that is confusing me :-)
I think the most confusing aspect of the existing curve program, with the
exception of Fredrik's, is the fact that the control points are tricky to
position correctly. Fredriik's LDraw mode solves this by dynamically
determining the control points.
-Orion
|
|
Message has 1 Reply:
 | | Re: *** Start celebrating .... NOW
|
| (...) If memory serves me well, in Fredrik's Ldraw mode you specified the endpoints in terms of orientation as well as coordinates, stated the number of joints and it calculated the rest. Certainly a good system for many instances as that (...) (22 years ago, 27-Dec-02, to lugnet.cad.mlcad)
|
Message is in Reply To:
20 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
