| |
I think Gary (blessing) is right and this is a problem with the new
version.
I used MLCad 1.99 and all works out fine!
Mark Chittenden wrote:
>
> I think you may have some bad DAT files - the two specific pieces (3046, 3066)
> renders ok in my MLCad:
>
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=66854
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=66855
>
> Mark C.
>
> In lugnet.cad.dat.parts, Jaco van der Molen writes:
> > I have noticed this specific problem myself, but never gave it any
> > attention, because like you say it is only visible from the side. It is
> > the same with many (inverted) slope bricks like 4287, 3747, and so on.
> > See http://ucoms.novice.nl/lego/mlcadSlopes.gif
> >
> > Jaco
> >
> > Andy Lynch wrote:
> > >
> > > Now that you mention it, there is also a problem with part #3660 (Slope
> > > Brick 45 2 x 2 Inverted
> > > ), but only when viewed from the side.
> > >
> > > Here is a snapshot:
> > > http://www.andyandjackie.com/lego/temp/mlcad3660.jpg
> > >
> > > -Andy Lynch
> > >
> > > ----- Original Message -----
> > > From: "Jaco van der Molen" <jmolen@globalxs.nl>
> > > To: <lugnet.cad.dat.parts@lugnet.com>; <lugnet.cad.mlcad@lugnet.com>
> > > Sent: Friday, August 31, 2001 2:34 AM
> > > Subject: Strange rendering of #3046 in MLCad
> > >
> > > > Can anyone explain why part #3046 (Slope Brick 45 2 x 2 Double • Concave)
> > > > renders like this:
> > > > http://ucoms.novice.nl/lego/mlcad3046.jpg in MLCad?
> > > > In all other programs it is good.
> > > >
> > > > Greetingz...
> > > >
> > > > Sjaacko
|
|
Message is in Reply To:
7 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
