Subject:
|
Re: LDD Model of GG-1 Electric Locomotive - Advice Requested
|
Newsgroups:
|
lugnet.trains, lugnet.cad.ldd
|
Date:
|
Sat, 19 May 2007 16:12:17 GMT
|
Viewed:
|
232 times
|
| |
|
|
In lugnet.trains, William R. Ward wrote:
| |
It’s also not hinged to another truck; it only has to rotate around its
center point. Being attached to the motor truck, the 3-axle trucks in the
GG1 are being pulled a little bit off center as the wheels go into the curve,
and I think that’s why the 3-axle truck can’t make it in this case.
I’ll play around with the trucks at some point - but the layout won’t require
traversing the curved side of any switches at the show so I’ll live with it
as-is for now.
|
Bruce Chamberlain postulated that the problem is due to one of the 3-axle trucks
being *pushed* through the curve rather than pulled. I suspect that a rubber
band between the two 3-axle trucks would help - I will try that sometime.
--Bill.
|
|
Message is in Reply To:
12 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
