 | | Re: LPub and Lsynth page for tracking enhancement requests and bug fixes
|
|
(...) Looking at the above list seriously..... You list a number of sub-model specific desires including: 1. view angle on a sub-model basis. You already have this using MLCad's ROTSTEP meta-command. ROTSTEP only applies to the file that contains (...) (20 years ago, 4-Oct-04, to lugnet.cad.dev)
|
| |
| | Re: LPub request
|
|
(...) The PLIST BEGIN SUB meta solution is fine. My problem was due to a lack of knowledge regarding LPub META commands. -Orion (20 years ago, 4-Oct-04, to lugnet.cad.dev)
|
| |
| | Re: LPub and Lsynth page for tracking enhancement requests and bug fixes
|
|
(...) My solution to the above is to give you explicit control over construction image render window size and PLI render window size. You can set these sizes small for test runs. Is this acceptable? It will be available in the next LPub release. (...) (20 years ago, 4-Oct-04, to lugnet.cad.dev)
|
| |
| | Re: LPub request
|
|
(...) I'm adding support for s and 48 in lieu of the pathing solution Lars' will be providing. If your flexible axle is produced by some known tool, I'm willing to add supprt for flex axle recognition to LPub. Orion, could you email an example? (...) (20 years ago, 4-Oct-04, to lugnet.cad.dev)
|
| |
| | Re: LPub request
|
|
(...) Hi Orion, I never got feedback from you about the PLIST BEGIN SUB solution outlined above. LPub recognizes parts synthesized with LSynth and tries to determine the part being synthesized. It recognizes flexible axles and determines the length. (...) (20 years ago, 4-Oct-04, to lugnet.cad.dev)
|
