 | | LDBoxer - Next Step and My Datsville Plans
|
|
So far, LDBoxer has replaced all bricks and plates that has both top studs and bottom studs/tubes covered by non-transparent parts. Next step is to eliminiate drawing bottom studs/tubes when only top studs are visible, and vice versa. Many models (...) (20 years ago, 15-Jun-04, to lugnet.cad.dev)
|
| |
| | Re: LDBoxer - Next Step and My Datsville Plans
|
|
In lugnet.cad.dev, Tore Eriksson wrote: [Lot of snippage] (...) hi tore, with the release of MLCad 3.10 there are now at least two progs who support custom folders. instead of messing up my PARTS\ and P\ folder I wish I could define something like (...) (20 years ago, 21-Jun-04, to lugnet.cad.dev)
|
| |
| | Re: LDBoxer - Next Step and My Datsville Plans
|
|
(...) That's not a bad idea, but the advantage of messing up the PARTS\ folder is that no extra adjustment or setup will be required. (...) "121 Messages in This Thread" - It's very hard for anyone who did not participate in the discussion to find (...) (20 years ago, 21-Jun-04, to lugnet.cad.dev)
|
| |
| | Re: LDBoxer - Next Step and My Datsville Plans
|
|
(...) Well, I tried to pull you into the discussion at least twice, by mentioning your boxer subdirectories, but no luck. (URL) think some sort of consensus *was* reached and Lars was working on some reference code to handle it. But I have to admit, (...) (20 years ago, 21-Jun-04, to lugnet.cad.dev)
|
| |
| | Re: LDBoxer - Next Step and My Datsville Plans
|
|
(...) (snip) (...) I *am* working on it, though slowly :-( The idea is that you can specify any number of part directories, e.g.: <MODELDIR> <LDRAWDIR>\P <LDRAWDIR>\Boxer <LDRAWDIR>\Boxer\B <LDRAWDIR>\Boxer\B\A <LDRAWDIR>\Boxer\BB <LDRAWDIR>\PARTS (...) (20 years ago, 22-Jun-04, to lugnet.cad.dev)
|
